Installing the module

QUADSCOPE contains some parts that may be susceptible to damage from Electrostatic Discharge (ESD). Please avoid touching the exposed pins on the back of the module.

Connect the module to your Eurorack power supply using the supplied ribbon cable. If using a different cable please take note of the position of the -12V wire (red stripe).

Getting started

Connect the output of a module (eg. oscillator) to one of the QUADSCOPE input sockets using a mono patch cable. Connect the corresponding QUADSCOPE output socket to the input of another module (optional).

Adjust the horizontal scale (timebase) using the right knob.

Adjust the vertical scale using the left knob. When more than one input channel is used, change the selected channel using CH SEL button. The channel selection LEDs will show which is the selected channel.

Adjust the vertical position by pressing the right knob and at the same time turn the left knob.

Function selection

Press the TOP WINDOW BUTTON (see last page of this guide). Highlight the function by turning the right knob and activate it by pressing the right knob

Enable split-screen and dual timebase

Press the BOTTOM WINDOW BUTTON and select a function using the right knob (turn to highlight, press to activate). This will split the screen into two windows.

Changes to the horizontal scale (and some other settings) will be applied to the currently selected window. Change the currently selected window by pressing the CH SEL button. The window selection LEDs will show which is the currently selected window (it is the one containing the selected channel).

To exit split-screen mode, press the BOTTOM WINDOW BUTTON and select Off using the right knob.

Extra adjustments

Press the ADJUST button. Turn the left knob to select the setting to adjust. Turn the right knob to change the value of the setting. Press the ADJUST button again to close the ADJUST window.

Main menu

Press the MENU button to access more configuration options and miscellaneous functions.

See the full guide for details.