QUADSCOPE User Guide

Main Menu

The main menu is used to access various settings of QUADSCOPE as described below. Press the MENU button to access the main menu.

Channels

Each channel can be set to one of these modes:

Auto Detect

The channel will only be displayed if a (mono) patch cable has been in inserted into the corresponding channel input socket.

Channel On

The channel will always be displayed.

Channel Off

The channel will never be displayed.

Display

Here you will find some settings that affect the display and LEDs

Minimal Mode

Hides the grid, measurements and other potentially distracting content on the screen. You can quickly toggle between minimal an non-minimal mode by pressing the right knob and then pressing the menu button while the right knob is still pressed.

Brightness

Changes the brightness of the screen. Use the right knob to adjust the brightness. Press any button when done.

Upside Down

Enable this to show the QUADSCOPE display upside-down (i.e. rotate it by 180 degrees). QUADSCOPE will need to be restarted once this setting is change. To do this, press the right knob and left knob and while they are pressed, press ADJUST.

Activity LED

This can be used to stop the Activity LED (between the two knobs) from blinking.

Vert/Horz Popup

Normally when you change the vertical or horizontal scale, a popup window will be displayed momentarily to indicate the new value. This settings allows you to disable the popup window.

Saved Settings

QUADSCOPE will save your settings by default so that when you restart your system the QUADSCOPE configuration will be the same as when you last used it. The exceptions are horizontal scale, vertical scale and position, trigger lever and tuner reference pitch. Those particular settings will revert to their factory default value when QUADSCOPE is restarted. This behavior can be changed. See below.

Config > Mode

When set to 'Auto Save' changes to QUADSCOPE settings are automatically saved and will be reloaded when QUADSCOPE starts up.

When set to 'Manual Save', changes will only be saved when 'Save Now' is selected from the Saved Settings menu.

Config > Save Horz

Save changes to the horizontal scale setting. We suggest you leave this disabled so help avoid aliasing issues. See beware of aliasing.

Config > Save Vert

Save changes to the vertical scale and position settings.

Config > Save Trigger

Save changes to the trigger level setting. Changes to the trigger channel are never saved.

Config > Save Tuner Ref

Save changes to the tuner reference pitch.

Clear Saved

Clears all of the currently saved settings. The QUADSCOPE will need to be restarted for the changes to come into effect.

Save Now

Save all setting changes. This is only really useful when the mode is set to 'Manual Save'.